🪁 Focus St Stage 3 Requirements

hpfp is out of steam around 350-375 whp. i have a built 2.3 stroker with a gen2 2867 turbo. i make 365 whp 365 wtq on 93. the car makes 20.5 boost at 3000 and holds through 7000. Stage 3 eCQM Requirements • EPs must attest to . 6 . out of 47 available eCQMs. o. 6 outcome measures. o. 27 high priority measures. o. 14 remaining measures • Priority Level 1: If relevant, at least one eCQM should be an outcome measure. o. Priority Level 2: If no outcome measure is relevant, at least one eCQM should be a high priority The Focus is a family hatchback whereas the Fiesta is a supermini, so you should pick the Focus ST if you need extra space and can justify the extra expense. Rear legroom is the most obvious area of difference: the Focus has 57mm more legroom for rear-seat passengers than in the Fiesta ST. The back of the Focus is easier to access, too, given Description. Stage 3 – Requires the vehicle to be fitted with the following. Collins Performance specialize in all types of ECU Remapping and Engine Tuning for your vehicle, helping maximize your driving pleasure. ECU Remap for a petrol or diesel engine will vastly improve your driving pleasure. With over 40 years’ experience on upgrading COBB Flat Foot Shift (MT Only): Improve shift times and keep boost built during shifts. Flat Foot Shifting can hold engine RPM at a set RPM between 3000-8000 RPM during shifting. This feature is enabled in COBB OTS maps. (Fiesta ST, Focus ST, Focus RS & Mustang Only.) COBB Launch Control: Adjust Launch Control on the fly with 6 pre-configured 2015 – Exit Stage 1. The 2015 reporting period for all EPs is any consecutive 90 days from Jan. 1, 2015, through Dec. 31, 2015. EPs can attest to MU beginning Jan. 4, 2016, and must complete Damond Motorsports Oil Catch Can kits come with everything needed for an optimized Oil Catch Can system. An oil catch can is, in a sense, a filter for the positive crankcase ventilation system. Here is our install guide for the Stage 1 Location 1 kit. Tools required/purpose: Jack and jackstands or lift or ramps/to lift the car Socket wrench: Long 6” extension/remove intake manifold bolts 7mm Repeat this pattern 3 times. SEC AIR/CCM (Engine) - 9. Bring your Ford Focus to a stop. Idle with transmission in drive (neutral for M/T) for 2 minutes. CCM (Trans) - 10. If your Ford has a manual transmission, go ahead and accelerate from 0 to 50 MPH, continue to step 11. LhR3p.

focus st stage 3 requirements